Cropico 3000 SERIES Instructions d'exploitation télécharger pdf (Page 11)

3000.doc Iss. 2/00

The channels available to add to the scanning list are designated A0 and B0 (A0…A4 , B0…B4 if the

extended scanner option is fitted). The Flashing channel may be added with Add key or deleted with

the Del key moving between the channels with the < > keys. Once a channel is added to the scan list

the channel is highlighted, pressing the OK key stores that scanning sequence.

To set the number of scan cycles and the delay between cycles select the Timer and the above menus

will be displayed. The changeable parameters will flash. To change the flashing parameter press Edit

and enter the appropriate number of Cycles 0 to 9999 or continuous. Pressing the Clear key returns to

the default setting. The following may be set Cyc - This is the number of scanning cycles any number

between 1 and 9999, continuous can also be set. NOTE if the data logger is turned on then the number

scan cycles is limit to 4000 readings. Delay - This sets the delay before the scanner cycle starts and

may be set between 00:00:00 and 59:59:59. Rate - This sets the time between each channel selection

and may be set between 00:00:00 and 59:59:59.

Example: Set Cyc to 10

Set Delay to 00:10:00

Set Rate to 00:00:40

The channels will be scanned 10 times with a start delay of 10 minutes and 40 seconds delay between

each channel selection.

The measurement display will start in the measurement Hold position Press TRIG to start the scan

cycle.

A0 Pt100 EN60741 R0 = 100.000 a = 3851 4wre

+ 100.000

-------------------------------------------------------------------------------

Scanning list edit: SL1

A0 B0

< > Add Del Quit OK

A0 Pt100 EN60741 R0 = 100.000 a = 3851 4wre

+ 100.000

-------------------------------------------------------------------------------

Cyc = Cont Delay = 00:00:00 Rate =

00:00:00

< >` Clear Edit Quit OK

A0 Pt100 EN60741 R0 = 100.000 a = 3851 4wre

+ 100.000

Input =138.500 Ohm +I Busy

Hold SL1 0/10

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

Cropico 3000 SERIES Instructions d'exploitation Page 11